There are many ways to cut a cement board just like there are many other ways for you to do anything you set your mind to but not every single way can be the best way which is why we’re going to show you three different ways for you to cut a cement board and still get pretty good results, let’s take a look at these great techniques:
Using a circular saw
This is by far one of the easiest ways to cut cement board, circular saws usually have a redundant abrasive blade which cuts through the board as if it was slicing through butter however the easiest way is not always the best way, using a circular saw can produce way too much dust and debris and depending on the type of blade that your saw uses the act of actually cutting through a cement board can be way too tough on it so if you are not sure about the type of circular saw you have then it might be a better idea for you to approach this task in a different way. Some people don’t care about their saws and if they break they always have a few extra hundreds to buy a new one, if this sounds like you then by all means go ahead and experiment a bit.
Using cement Shear equipment
Using cement Shear can be one of the best ways to cut to a cement board, this tool looks much like a power drill in fact; the whole mechanics is 80% similar to that of a power drill with the difference that instead of a drill it has a scissor-like attachment at the very tip. Using cement Shear equipment makes a lot of noise just like using a circular saw so unless you’re doing this throughout the day then you might want to take a look at the next option for you to cut through a cement board. Furthermore this type of tool can also produce a lot of debris but on the plus side you have a lot of control over the direction and the way that you are cutting through the board and as we all know what you’re doing to stop the job precision does really matter.
Using a single carbide tip tool
This is a rather rudimentary technique used by many folks who preferred to go old school when cutting this type of boards. This tool looks much like a razor knife to the main difference is on the cutting blade which is carbide tipped. First you need to mark the section that you’re going to cut through with a pencil or a marker, make sure that you’re able to see the line very well. Then using the carbide tip tool start running the blade down the line you just made in order to scrape or cut a clear path, you may have to do this several times until you are able to get through the board. Once all the cutting is complete then apply pressure to the back of the board behind the cut line, snap the board and take your cutting tool and start scraping along the line to separate the board in two pieces. This technique doesn’t produce much debris and even if you do it at midnight it won’t be as loud as using the tools mentioned above.
To learn more about wheelbarrow cement mixers as well as cement Shear make sure to stop by our website at cementmixerdeals.com